The table below is a list of Subaru Specific P Codes (They have been collated from product training notes)
| P1086 | Swirl control position sensor, Low, Left bank |
| P1087 | Swirl control position sensor, High, Left bank |
| P1088 | Swirl control position sensor, Low, Right bank |
| P1089 | Swirl control position sensor, High, Right bank |
| P1094 | Swirl control valve actuator, Disconnection, Right bank |
| P1095 | Swirl control valve actuator, Short, Right bank |
| P1096 | Swirl control valve actuator, Disconnection, Left bank |
| P1097 | Swirl control valve actuator, Short, Left bank |
| P1101 | Neutral position switch, High input |
| P1110 | Atmospheric pressure sensor, Low input |
| P1111 | Atmospheric pressure sensor, High input |
| P1112 | Atmospheric pressure sensor, Range / Performance problem |
| P1115 | Communication line (engine control cut signal), High input |
| P1116 | Communication line (engine control cut signal), Low input |
| P1121 | Neutral position switch, Low input |
| P1130 | Front O2 sensor malfunction (RH bank / Open circuit) |
| P1131 | Front O2 sensor malfunction (RH bank / Short circuit) |
| P1134 | Communication line malfunction (sensor CPU-ECM) Front oxygen (A/F) sensor micro-computer problem. |
| P1135 | Front O2 sensor malfunction (LH bank / Open circuit) Bank 2 and sensor 1 oxygen (A/F) sensor (frony LH) circuit malfunction (open circuit). |
| P1136 | Front O2 sensor malfunction (LH bank / Short circuit) Bank 2 and sensor 1 oxygen (A/F) sensor (frony LH) circuit malfunction (short circuit). |
| P1139 | Front O2 sensor heater malfunction (RH bank) Bank 1 and sensor 1 oxygen (A/F) sensor (front RH) heater circuit range / performance malfunction. |
| P1140 | Front O2 sensor heater malfunction (LH bank) Bank 2 and sensor 1 oxygen (A/F) sensor (front LH) heater circuit range / performance malfunction. |
| P1142 | Throttle positon sensor circuit range / performance malfunction (low input) |
| P1146 | Intake air pressure sensor, Range / Performance problem (high input |
| P1230 | Fuel pum controller malfunction |
| P1244 | Wastegate control solenoid valve, Range / Performance problem (Low input) |
| P1245 | Wastegate control solenoid valve malfunction (fail-safe) |
| P1301 | Fire due to increased exhaust temperature |
| P1312 | Exhaust gas temperature circuit malfunction |
| P1480 | Cooling fan relay 1 circuit, High input |
| P1507 | Idle air control system malfuction (fail-safe) |
| P1518 | Starter switch circuit, Low input |
| P1520 | Cooling fan relay 1 High input |
| P1544 | High exhaust temperature detected |
| P1560 | Back-up voltage circuit malfunction |
| P1570 | Immobilizer antenna |
| P1571 | Reference code incompatabilty |
| P1572 | Immobilizer circuit failure (except antenna circuit) |
| P1574 | Key communication failure |
| P1576 | EGI control module EEPROM |
| P1590 | Neutral position switch circuit high input |
| P1591 | Neutral position switch circuit low input |
| P1594 | Communication line (TCM diagnosis signal) malfunction |
| P1595 | Communication line (TCM diagnosis signal) Low input |
| P1596 | Communication line (TCM diagnosis signal) High input |
| P1698 | Engine torque control cut signal circuit low input |
| P1699 | Engine torque control cut signal circuit high input |
| P1700 | Throttle position sensor malfunction for Auto transmission |
| P1701 | Cruise control set signal malfunction |
| P1703 | Low clutch timing solenoid valve malfunction |
| P1711 | Communication line (engine torque control signal 1) malfunction |
| P1712 | Communication line (engine torque control signal 2) malfunction |
Last Reviewed: 23 April 2008Copyright © 2004...2009 Mark Stammers mark@peugeotmt.co.uk